Arkansas · PSI

Arkansas Concrete - Commercial Exam Practice Exam

30 questions 75 minutes 70% to pass 6 topics 2:30 per question Open book 141 questions in pool
Free Cheat Sheet Official Bulletin
Free

Free Practice Exam

$0

Test your knowledge with 10 questions from our pool of 20 free questions.

  • 10 questions per attempt
  • 30 minute time limit
  • Unlimited attempts
  • A new mix each time
  • Instant results
No account required.
Full Exam

Full Practice Exam

$9.95

Complete exam simulation matching the real PSI test format.

  • 30 questions (same as real exam)
  • 75 minute time limit
  • 6 topic areas covered
  • 141 questions in pool
  • Detailed explanations
Price per attempt. Never the same exam twice: each attempt draws a fresh set of questions.
Not sure which exam you need? Text us: (813) 582-5360
Texts preferred · 9am–9pm Central
Want a guided study plan? Study Course: topic briefs, 6 topic quizzes and this full exam, plus the Business and Law exam. $59.95/month.
See the study course

Arkansas Concrete - Commercial Practice Exam Guide

Built from the official PSI exam bulletin. View the bulletin

What's on the exam

Questions per topic, out of 30
General Concrete9
Layout and Excavation6
Formwork4
Reinforcing Steel4
OSHA Safety4
Estimating3

This practice exam is laid out like the official content outline for the Arkansas Concrete - Commercial exam: Estimating, Layout and Excavation, Formwork, Reinforcing Steel, General Concrete, OSHA Safety.

Two ways to practice: the free practice exam gives you 10 questions per attempt, as often as you want. The full practice exam gives you 30 questions on a 75 minutes clock, with a new draw from our question bank every time.

6 topics

Estimating 3 items

Layout and Excavation 6 items

Formwork 4 items

Reinforcing Steel 4 items

General Concrete 9 items

OSHA Safety 4 items

3 questions

Sample 1 — General Concrete

Question: You are a commercial concrete contractor planning a wall pour. Your project engineer asks where vertical construction joints in walls should be located when construction joints are not shown on the drawings. According to best practice, what is the maximum recommended horizontal length of a single concrete wall placement between vertical construction joints?

  • A. 40 ft
  • B. 20 ft
  • C. 30 ft
  • D. 50 ft

Correct Answer: A

According to The Contractor's Guide to Quality Concrete Construction, Chapter 7, a horizontal length of concrete placement greater than 40 ft (12 m) long in walls is not normally recommended for vertical construction joints.

Reference: Contractor's Guide to Quality Concrete Construction (4th ed.), Chapter 7 – Joints and Embedments in Structures, Page 113

Sample 2 — Layout and Excavation

Question: You are finishing the site work around a new commercial building where no lot lines or physical obstructions interfere with the grading. What minimum slope away from the foundation, and over what minimum horizontal distance measured perpendicular to the face of the wall, is required for the ground immediately adjacent to the foundation?

  • A. 5 percent for 20 feet
  • B. 2 percent for 10 feet
  • C. 2 percent for 6 feet
  • D. 5 percent for 10 feet

Correct Answer: D

IBC Section 1804.4 requires the ground immediately adjacent to the foundation to be sloped away from the building not less than one unit vertical in 20 units horizontal (5-percent slope) for a minimum distance of 10 feet measured perpendicular to the face of the wall. A reduction to a 2-percent slope (1:48) is permitted only where climatic or soil conditions warrant, and the 2-percent figure also applies to swales and impervious surfaces within 10 feet.

Reference: IBC 2015 Chapter 18 — Section 1804.4 Site Grading

Sample 3 — Formwork

Question: The approximate unit weight of normalweight concrete used for formwork design calculations is ______ lb/ft³.

  • A. 100
  • B. 125
  • C. 150
  • D. 175

Correct Answer: C

Concrete is a heavy material, approximately 150 lb/ft³ (2400 kg/m³) for normalweight concrete (more than twice the weight of water). This value is critical for formwork design as it directly affects the loads that forms must support.

Reference: Contractor's Guide to Quality Concrete Construction (4th ed.), Page 70

Your first attempt is an inspection, not a final grade. The results page breaks your score down by outline topic, so you can see which areas need work. Compare it with the real exam's passing score, 21 correct answers out of 30 scored questions, and keep practicing until you pass consistently.

  • Answer what you know first and bookmark the rest. Our practice exams let you bookmark and come back.
  • Work your bookmarks on the second pass.
  • Keep your pace. The real exam works out to about 2 minutes 30 seconds per question.
  • After each attempt, look up each missed question's reference in your book and read the section.

Questions 30 questions
Time limit 75 minutes
Passing score 21 correct answers out of 30 scored questions
Books in the exam room Open book

Source: Arkansas Contractors Licensing Board - Concrete Commercial, 10/17/2220. Check the bulletin before test day: fees and rules can change.

10 free questions30 min · no account